How To Turn On Water Heater Rheem. It looks like you do in fact have to depress the knob in order to turn it so avoid using force. Try not to eliminate the indoor regulator defensive cover.
How to turn down the temperature on rheem water heaters. You can also switch it by pressing down the red button left. Turn the temperature dial to an initial setting of 120 degrees by lining the indicator mark to the top center.
Turn The Water Heater's Gas Valve Switch To The Off Position, Wait For A Few Seconds And Then.
Push down the red button to the left of the. The circuit breaker is right inside the electrical panel of your home. Then press the red reset button.
This Same Instruction Set Should Be Available As A Sticker On Your Unit.
To reset the temperature restricting control: Similarly, it is asked, how do i turn down my rheem water heater? Remove the lid from the panel and look beneath the insulation for the reset button.
Find The Large Indicator Notch On The Dial.
Turn the temperature dial to an initial setting of 120 degrees by lining the indicator mark to the top center. Find the water heater circuit on the electrical panel by going to the panel. To turn on the pilot, continue pressing the red button until the piezo igniter strikers appear close to the gas knob.
Push Down The Red Button To The Left Of The Gas Knob.
How to turn down the temperature on rheem water heaters. Take off the coat access boards and protection. If it clicks you have reset it.
Turn Off The Power Then Remove The Panel And The Insulation Behind It.
The button is at the top of the thermostat. You can also switch it by pressing down the red button left. Below is a picture of the lighting instructions for your water heater taken from rheem's website.